P&E Microcomputer Systems XPC560P EVB User Manual - page 41
of
53
xPC560P EVB User Manual
37
5
xPC560PADPT144S HARDWARE & JUMPER SETTINGS
5.1
Boot Configuration
The following jumpers affect the operation of the processor as it initially
comes out of the reset state:
J7 – FAB Configuration
Controls whether the processor boots from internal FLASH or from a serial
interface (CAN, SCI)
J8 – ABS0 Configuration
This jumper configures the ABS[0] pin.
J9 – ABS2 Configuration
This jumper configures the ABS[2] pin.
Jumper Setting
Effect
1+2
The MPC560xP processor uses serial boot mode
2+3 (default)
The MPC560xP processor uses internal boot mode
Jumper Setting
Effect
1+2
The ABS[0] pin is pulled up logic high
2+3 (default)
The ABS[2] pin is pulled down logic low