Pacific Energy granville Installation And Operating Instructions Manual - Surround Assembly
12
040805-24
GRNA
# 5055.651
Surround Assembly
1) Lay Parts A, B, and C face down on a flat, non-marking
surface. (Fig. #16) Fasten together with spring clips
through holes at points "D". (Fig. #19)
2) Lift the surround assembly to the upright position and
make sure the front face is even at the joint.
3) Assemble the three brass trim pieces using the enclosed
hardware. Slide Part F into the back corners of the brass
trim and tighten screws. Ensure the mitred corners fit
tightly and evenly. (Fig. # 17)
4) Slide the assembled brass trim over the surround from the
top. (Fig. # 16)
5) Tighten the retaining screws at the bottom of each brass
trim side. (Fig. # 20)
Fig. # 17
Fig. # 18
6) Connect the wire from the gas control valve to the on/off
rocker switch in the brass trim. (Fig. # 18)
7) Slide pre-assembled surround on to Insert. Do not lift the
assembly by grasping the brass trim. The surround is
held in place by screws (2 each side), just inside the casing
near the top and bottom. Push surround back until snug
and even with front face of Insert. Fasten in place.
Fig. # 19
8) Push the entire appliance back until the surround is in
contact with the fireplace.
Fig. # 16
Fig. # 20
f i r e - p a r t s . c o m