Pacific Energy NEO 2.5 Installation And Operating Instructions Manual - page 11
141014-20
NEO 2.5 INSERT-A
11
©PACIFIC ENERGY FIREPLACE
PRODUCTS LTD.
Maintenance Checks
Check the following parts for damage such as cracks, excessive corrosion, burned out sections and
excessive warping: (See website for descriptions and more detail)
Weekly:
- Firebrick - Visual, for cracking.
- Door Gasket - sagging, placement, damage.
- Top heat shield and mounting bolt. (visible above front edge of bafl e.)
Monthly
- Brick rail tabs and brick rails.
- Air riser tube in the back of the fi rebox.
- Back side of airwash chamber.
- Baffle locking pin.
- Boost tube cover.
When Cleaning the
Chimney System:
- Top baffle board/blanket.
- Top heat shield and mounting bolt.(visible above front edge of bafl e.)
- Baffle.
- Brick Rails.
- Manifold.
Blower:
- The blowers should be cleaned out a minimum of every six months by using a vacuum on the blower
wheel intake openings to remove any dust and debris. See “Blower Replacement” section on page 13
for instructions on how to access the blowers.
Baffle:
- Some warping of the baffle is normal(up to 1/4” or .65cm).
- Replace if the baffle has permanent warping greater than this or has cracking or breakage.
- Please contact your Dealer if you experience any of the damage listed above. Continuing to operate
your stove with broken parts may accelerate damage to other parts and may void your warranty