Pacific Energy NEO 2.5 Installation And Operating Instructions Manual - page 14
14
NEO 2.5 INSERT-A
141014-20
©PACIFIC ENERGY FIREPLACE
PRODUCTS LTD.
Surround Assembly and Installation
1) Attach the surround back to the surround mounting brackets
on the unit with the four screws provided.Fig. #10
2) Push the entire appliance back until the surround assembly
is in contact with the fi replace facing.
3) Attach the front surround by inserting the surround hooks
into the slots between the fan mount brackets and the
fi rebox on both sides and sliding it down to engage the
hooks onto the brackets. Fig. #11
Fig. # 10
Fig. # 11
Combustion Air
Consult local building codes regarding combustion air supply.
Intake or combustion air can be supplied to the Insert in one
of two ways:
1) Outside air supply: Remove the cover from ash clean out
in the existing fi replace. Place a rodent screen in place of
the cover. Install the Insert as described in the "Installa-
tion" section, making sure not to cover the opening of the
air inlet. When the installation is complete, seal the back
surround to fi replace. This will ensure combustion air is
drawn from outside the house and under the unit.
2) Room air supply: The insert can get combustion air from
the front under the fi rebox but it must have adequate air
for combustion provided in the room the unit is installed
in. This may involve providing make up air from outside
the house.
SURROUND MOUNTING BRACKETS
F RO N T S U R RO U N D
MOUNTING BRACKET
HOLES
SURROUND HOOKS