Pacific Energy NEO 2.5 Installation And Operating Instructions Manual - page 6
6
NEO 2.5 INSERT-A
141014-20
©PACIFIC ENERGY FIREPLACE
PRODUCTS LTD.
Operation
CAUTION: Never use gasoline, gasoline type lantern fuel,
kerosene, charcoal lighter fl uid or similar liquids to start or
“freshen up” a fi re in this heater. Keep all such liquids well
away from the heater while it is in use.
CAUTION: Hot while in operation. Keep children, cloth-
ing and furniture away. Contact may cause skin burns.
Your PACIFIC ENERGY heater is designed for many years of
trouble free operation. Over fi ring the appliance will shorten
the life of the product. Failure to recitify an over fi ring condition
can be hazardous and may void the manufacturer’s warranty.
NOTE: Left and Right as referred to in this manual are consid-
ered your left and right when facing the front of the woodstove.
Wood Selection
This heater is designed to burn natural wood only. Higher
efficiency and lower emissions generally result when burning
air-dried seasoned hardwoods, as compared to softwoods or
too green or freshly cut hardwoods.
Wood should be properly air dried (seasoned) for six months
or more. Wet or undried wood will cause the fi re to smoulder
and produce large amounts of creosote. Wet wood also pro-
duces very little heat and tends to go out often.
DO NOT BURN :
-Salt water wood *
-Treated wood
-Wet or green wood
-Coal/charcoal
-Garbage/Plastic *
-Solvents
* These materials contain chlorides which will rapidly
destroy metal surfaces and void warranty.
Do not burn anything but wood. Other fuel, e.g. charcoal,
can produce large amounts of carbon monoxide, a tasteless,
odourless gas that can kill. Under no circumstances should
you attempt to barbecue in this heater.
How to Test Your Wood
Add a large piece of wood to the stove when it has a good
large bed of coals. It is dry if it is burning on more than one
side within one minute. It is damp if it turns black and lights
within three minutes. If it sizzles, hisses and blackens without
igniting in fi ve minutes it is soaked and should not be burnt.
WARNING: Do not use grates or andirons to elevate the
fuel. Burn directly on the fi rebricks. Replace broken or
missing bricks. Failure to do so may create a hazardous
condition.
Your PACIFIC ENERGY heater is designed for many years of
trouble free operation. Over fi ring the appliance will shorten
the life of the product. Failure to recitify an over fi ring condition
can be hazardous and may void the manufacturer’s warranty.
Lighting the Fire
WARNING: Never use chemicals or any other volatile
liquid to start a fi re.
1) Adjust air control to “High” position(all the way to the left)
and open door.
2) Place crumpled newspaper in the centre of the heater and
criss-cross with several pieces of dry kindling. Add a few
small pieces of dry wood on top.
3) Ignite the paper and close the door.
4) After the fi re has established itself, open the door and add
a few small logs. Close door.
5) Begin normal operation after a good coal base exists and
wood has charred.
Normal Operation
1) Set air control to desired setting. If smoke pours down
across the glass (waterfall effect), this indicates you have
shut the control down too soon or you are using too low a
setting. As every home’s heating needs vary (i.e. insula-
tion, windows, climate, etc.), the proper setting can only
be found by trial and error and should be noted for future
burns.
2) To refuel, adjust air control to “High” position(all the way
to the left), and give the fi re time to brighten. Open door
slowly, this will prevent backpuffing.
3) Use wood of different shape, diameter and length
(recommended 18”(457mm)). Load your wood and try to
place the logs so that air can fl ow between them. Always
use dry wood.
4) Do not load fuel to a height or in such a manner that would
be hazardous when opening the door.
5) For extended or overnight burns, unsplit logs are preferred.
Remember to char the wood completely on ”High” setting
before adjusting air control for overnight burn.
WARNING: Always keep loading door closed when burn-
ing. This heater is not designed for open door burning.