QRS Music Technologies PMII Installation Manual - page 29
29
July 2013
Moun ng & Connec ng the Electronic Components
PMII Processor Descrip on
Powered Speaker Descrip on
A powerful amplifier with discrete output devices providing peak power output of 35 wa s when used on 115 AC volts.
An automa c on/off circuit, ac vated by an audio signal. The speakers will mute one minute a er the music stops.
A tri‐state power indicator with pilot LED to indicate the power "on" condi on in full brightness, "stand‐by" condi on in
half brightness, and "off" condi on with no brightness.
Treble and bass controls which allow you to adjust the treble and bass to cope with a par cular listening environment.
A simple, yet versa le, moun ng bracket is supplied for moun ng the AR speaker under your piano.
The new PNOma on II processor replaces both the tradi onal QRS processor and the QRS user controller. The
en re QRS Music library can be put on an SD memory card and inserted into the PMII unit. Control of the
system is best achieved when connected via a standard wireless access point and an iPad or Android device.
PNOma on II Processor with the SD Card Music Library, Moun ng brackets and screws
Pin‐Light Extension (PLx) Descrip on
The PLx box is used to extend two of the USB ports and two of the audio ports from the PMII processor to an
easily accessible loca on under the keybed. This box is also used to show the status of the system.
Pin‐Light Port Extender [PLx] [Six Lights; IR Sensor; Stereo & USB Ports; Microphone; Reset Bu on]
Wi‐Fi Device Descrip on
The Wi‐Fi device is the wireless link between the PMII processor and the iPad control device.
Universal power adapter (5V/1A, 100V~240V)
Cables: USB A to wireless power jack and RJ45 Ethernet
Velcro Strip [Use to a ach Wi‐Fi to beam or back post]
TL-
WR702N
...Electronic Components ‐ Descrip on
A ach speaker to piano beam using six screws
Verify that the red line voltage switch is set to 115