QRS Music Technologies PMII Installation Manual - Wi‐Fi Setup
Wi‐Fi Setup
44
July 2013
How to Configure the TP‐Link TL‐
WR702N
from Network to “Stand Alone” Mode
Select Se ngs and then Wi‐Fi on your iPad, iPhone or iTouch.
Select and connect to “QRSPNO Network”.
Select the Safari browser.
Enter the following address:
192.168.0.254 and press “Go”
Set a sta c IP address if you can’t connect to the TP‐Link. See [Select “Sta c”] in the “TP‐Link Reset” instruc ons.
Enter “admin” as the User Name and Password.
Press the “Log In” bu on.
Click “Quick Setup”
Click “Next”
Select “Router Mode”
Click “Next”
Change the SSID to QRSPNO
Set Channel to “Auto”
Under “Security Op ons:” select “Disable Security”
Click “Next”
Under “WAN Connec on Type” select “Dynamic IP”
Click “Next”
Under “MAC Clone” select “No”
Click “Next”
Click “Reboot”
Click “OK”
Restar ng
Wait for the TP‐Link configura on to finish and restart.
Close browser when 100% complete.
On the QRS PNOma on II remote control:
Press the following bu ons in sequence…
SHIFT FUNC 9 9 0
The third light should be green.
Press SHIFT INFO to confirm the 192.168.1.1 address.
Lighted bu on #3 on the PMII processor should be SOLID green.
The device is now ready for “Stand‐Alone Mode” on the PMII.
Select Se ngs and then Wi‐Fi on your iPad, iPhone or iTouch.
Select and connect to “QRSPNO”.
Open Safari and enter 192.168.1.1