QRS Music Technologies PMII Installation Manual - page 31
31
July 2013
Moun ng & Connec ng the Electronic Components
Moun ng the new PNOma on II processor to the piano and connect these cables.
‐
Mount and Connect the PMII Processor and the Op onal PNOscan (Record)
Having located the sustain pedal solenoid assembly, you can now locate the Power Supply chassis on the side of an
adjacent wooden beam beneath the piano's soundboard. You should a empt to locate the Power Supply chassis as
close to the belly‐rail as possible so as to avoid exceeding the length of the related cables. The moun ng can be placed
on either the wide or narrow side of the power supply.
Mount the Power Supply
“DRIVER Port B” [This is the 1‐1/2” flat gray cable going to the driver boards]
-
“POWER SUPPLY” [This is the 3/4” flat gray cable going to the power supply]
-
“KEYSCAN PRIMARY” ‐ QRS PNOscan Record Systems Only ‐
Black flat cable coming from the record system’s So ‐Shi circuit board.
Driver Port B
Power Supply
PNOscan
Silver contact side down
Mount and Connect the Wi‐Fi Adapter and Speaker
Plug the wireless power adapter into an AC outlet. There are two possible loca ons:
or
The un‐switched outlet [UNSW OUT] on the type A power supply, if it’s not being used.
The extension cord from the wall outlet that runs inside or under the piano.
Connect the Ethernet cable from the wireless to the Ethernet port on the PMII processor.
Using the Velcro strip supplied, a ach the wireless unit to the piano .
Connect your powered speaker to the PMII’s Audio #3 jack. Use the 1/8” stereo‐to‐RCA cable provided.
Mounting Brackets
Amplified Speaker
TL‐WR702N