QRS Music Technologies PMII Installation Manual - Wi‐Fi Setup
Wi‐Fi Setup
45
July 2013
The TP‐Link has been pre‐programmed from QRS so it’s not necessary to reset it. But, if the SSID name shown on the back of the TP‐Link ap‐
pears in your wireless network connec on list, it’s been reset.
To reset the WR702N, press and hold the “Reset” bu on on the side of the TP‐Link for 8 seconds, or un l the light blinks at lease 3 mes.
Select Se ngs and then Wi‐Fi on your iPad, iPhone or iTouch.
Select and connect to the TP‐Link (TP‐Link_50B880in our example).
Touch the blue circle to the right of the TP‐Link.
Select “Sta c” and enter the following:
IP address = 192.168.0.5
Subnet mask = 255.255.255.0
Router = 192.168.0.254
DNS = 192.168.0.254
Go back to your home screen...
Select the Safari browser.
Enter the following address:
192.168.0.254 and press “Go”
Enter “admin” as the User Name and Password.
Press the “Log In” bu on.
You may be asked for the TP‐Link’s password.
It’s located on the back of the TP‐Link.
Click “Quick Setup”
Click “Next”
Select “Router: Router Mode”
Click “Next”
Change the SSID to QRSPNO
Under “Security Op ons:” select “Disable Security”
Click “Next”
Under “WAN Connec on Type” select “Dynamic IP”
Click “Next”
Under “MAC Clone” select “No”
Click “Next”
Click “Reboot”
Click “OK” to confirm.
The TP‐Link will configure and restart.
Go to Se ngs / Wi‐Fi and connect to the QRSPNO.
Open Safari and navigate to 192.168.0.254
If necessary, enter “admin” as the ID and Password
You may have to enter “Sta c:” again. See above.
Under “Advanced Se ngs” click DHCP
Under DHCP Server” select “Enable”
Press “Save” and “OK”.
On the QRS PNOma on II remote control:
Press the following bu ons in sequence…
SHIFT FUNC 9 9 0
The third light should be green.
Press SHIFT INFO to confirm the 192.168.1.1 address.
Go to Se ngs / Wi‐Fi and verify your connected to QRSPNO
Open your Safari browser and enter the 192.168.1.1 address to connect to PMII.
How to Configure the TP‐Link TL‐
WR702N
to Stand Alone Mode a er a TP‐Link Reset