QRS Music Technologies PMII Installation Manual - Wi‐Fi Setup
Wi‐Fi Setup
43
July 2013
On the QRS PNOma on II remote control:
Press the following bu ons in sequence…
SHIFT FUNC 9 9 1
Third light flashes red/green and then solid yellow.
You can also switch PMII to Network Mode from your iPad:
Go to System Setup / Other Se ngs / Network Se ngs…
Turn OFF “DHCP Server Enable (Standalone)…
Turn ON “DHCP Enabled”…
Press the “Apply Changes” bu on…
Press “Yes” to confirm…
Press “Yes” again.
Select Se ngs and then Wi‐Fi on your iPad, iPhone or iTouch.
Select and connect to QRSPNO.
Select the Safari browser.
Enter the following address:
192.168.0.254 and press “Go”
Set a sta c IP address if you can’t connect to the TP‐Link. See [Select “Sta c”] in the “TP‐Link Reset” instruc ons.
Enter “admin” as the User Name and Password.
Press the “Log In” bu on.
Click “Quick Setup”
Click “Next”
Select “Bridge Mode”
Click “Next”
Click the “Survey” bu on.
Click “Connect” for the SSID of the network you wish to join.
Change the SSID to “QRSPNO Network”
Under “Security Op ons” choose the type of security (WEP or WPA)
Enter your network password in the “PassWord” box
Click “Next”
If prompted, change the channel se ng displayed.
Press “OK” and then do so and click “Next”
Select “Disable Security” (Unless you want to secure the network)
Click “Next”
Click “Reboot”
Click “OK” to confirm.
Connect to your home network
PLx light # 3 should be YELLOW.
Lighted bu on on the PMII processor should be FLASHING.
The TP‐Link is now linked to your home network and ready for “Network Mode” on the PMII.
If you did not hear the IP address press SHIFT and then INFO on the QRS remote control.
You may have to reboot PMII by unplugging from AC power and reconnec ng.
Open Safari enter the IP address heard from the speaker.
How to configure the TP‐Link TL‐
WR702N
from “Stand Alone” Mode to “Network Mode”