QRS Music Technologies PMII Installation Manual - Adjustment Procedures
Adjustment Procedures
37
July 2013
Pedal Adjust
Press “Pedal Adjust” and then slide the “Start/Stop Test” bu on to the right to start the adjustment.
Turn OFF the “Thump Reduc on” by sliding the bu on to the le .
The sustain pedal solenoid and the sustain dampers should start to cycle ON and OFF.
This procedure is not necessary on systems that do not have a sustain pedal solenoid, usually uprights .
Press the “‐” bu ons to set the “Ini al Drive” and “Hold” values to zero.
Watch the sustain dampers and press the Ini al Drive’s “+” bu on un l the dampers move off the strings.
Then, press the Hold “+” bu on un l the dampers li up and hold off of the strings.
Turn ON the “Thump Reduc on” by sliding the bu on to the right. Thump reduc on will pulse the pedal solenoid as
it’s release to break it’s fall and reduce noise.
Adjust the release up and down un l the solenoid drops quietly.
Stop the adjustment by sliding the “Start/Stop Test” bu on to the le .
Pedal Test
Press “Test Files”
Select “PedalKeySync.MID to test your pedal adjustment.