Raymarine ST60 Tridata Owner's Handbook Manual - Chapter 1: Operation
Chapter 1: Operation
1
Chapter 1: Operation
1.1 Getting started
Displayed information
Your ST60 Speed instrument provides the following:
• Speed information.
• Log, trip and water temperature information.
• Count-up and race-start timers.
CAUTION: Calibration requirement
The ST60 Speed instrument is calibrated to default settings when
supplied. To ensure optimum performance on your boat, this
product MUST be calibrated before use. Do NOT use the product
until it has been calibrated using the procedures in Chapter 4,
Calibration.
1.2 Normal operation
Use the flow charts in this Chapter to operate your ST60 Speed instrument. The
flow charts show the sequence of key presses and displays for the various
operating tasks. All key presses are momentary unless otherwise stated.
Speed information
The
speed
key gives access to current speed, maximum speed, average speed,
velocity made good (VMG) and speed over ground (SOG) information. Refer to
the
Using speed key
flow diagram to access the information you want.
Current speed
Speed measurement units can be either knots (KTS), miles per hour (MPH) or
kilometers per hour (KMH). The required units are selected during user calibration
(see
Chapter 4, Calibration
).
Maximum speed
The maximum speed is reset at power up. It can also be reset manually by pressing
the
reset
key for 3 seconds. The display shows the maximum recorded speed
since the last reset. This screen times-out to current speed if no user action occurs
for 7 seconds.