Raymarine ST60 Tridata Owner's Handbook Manual - Instrument
Chapter 3: Installation
13
• Have sufficient clearance inside the hull to fit the nut.
• Have 4 in (100 mm) of headroom to allow for withdrawal.
There must also be a viable route for the transducer cable to be routed to the
instrument.
Instrument
CAUTION:
The presence of moisture at the rear of the instrument could cause
damage either by entering the instrument through the breathing
hole or by coming into contact with the electrical connectors.
ST60 instruments can be fitted either above or below deck, provided the rear of
the instrument is sited where it is protected from contact with water.
Each instrument must also be positioned where:
• It is easily read by the helmsman.
• It is protected against physical damage.
• It is at least 9 in (230 mm) from a compass.
4.33 in (110 mm)
0.95 in
(24 mm)
0.6 in
(15 mm)
3.54 in (90 mm)
diameter
4.53 in (115 mm)
4.85 in (123 mm)
0.25 in
(6.2 mm)
1.4 in
(35 mm)
3.54 in (90 mm)
diameter
4.85 in (123 mm)
D5785-4
ST60 instrument dimensions
With standard
bezel
With low
profile bezel