Raymarine ST60 Tridata Owner's Handbook Manual - Suppression Ferrites
Chapter 3: Installation
15
Suppression ferrites
The following illustration shows typical cable suppression ferrites used with
Raymarine equipment. Always use the ferrites supplied by Raymarine.
Connections to other equipment
If your Raymarine equipment is to be connected to other equipment using a cable
not supplied by Raymarine, a suppression ferrite MUST always be attached to the
cable near the Raymarine unit.
3.2 Procedures
As it is not possible to describe procedures for all possible installation scenarios,
the procedures given here describe the broad requirements for installing Speed
transducers and the ST60 Speed instrument. Adapt these procedures as
appropriate, to suit your individual requirement.
CAUTION:
Where it is necessary to cut holes (e.g. for cable routing and
instrument mounting), ensure that these will not cause a hazard
by weakening critical parts of the vessel’s structure.
Unpacking
Unpack your ST60 equipment and check that the items described in the
Preface
are present.
Each ST60 instrument is supplied with a standard bezel for surface mounting.
Optional mounting kits are available for flush mounting and bracket mounting
the instrument. If you have ordered the flush mounting option a low-profile bezel
and four fixing screws are also provided.
D3548-6