Raymarine ST60 Tridata Owner's Handbook Manual - Response Settings
36
ST60 Speed Instrument Owner’s Handbook
Response settings
The response values for both SPEED and VMG determine the frequency at
which information is updated. A low number provides a smooth response and a
high number a much livelier update.
Use the
timer
(decrement) and
reset
(increment) keys to set the required value.
Response values are from 1 to 15 .
Boat show mode
CAUTION:
Do NOT enable this mode. It must only be used for demonstration
purposes.
Ensure that the Boatshow Mode Use is set to OFF . If necessary, use the
timer
or
reset
key to achieve this.
Factory defaults
You can use this screen to reset the operating parameters to the factory default
values. Use the
timer
and
reset
keys to make the required selection.
Note that the selection you make at this screen will be applied when you exit the
screen, so be sure you make the correct selection.
If you want to apply the factory defaults, ensure the display shows YES , but
if
you want to retain the current values,
ensure that the display shows
NO
.
Leaving Dealer calibration
Hold down the
speed
and
trip
keys for 2 seconds to save your settings, exit
Dealer calibration and resume normal operation.