Raymarine ST60 Tridata Owner's Handbook Manual - Race-Start Timers
Chapter 1: Operation
5
Once you have selected the required timer display, press the
reset
key to start the
timer running. When a timer is running, the delimiter (i.e. ‘.’or ‘:’) flashes. For lap
timing, press the
reset
key. To stop and reset a timer to the start value, hold down
the
reset
key for 1 second.
Once a timer is running, you can leave the timer page and select any other display.
The counter will continue to run in the background.
Race-start timers
You can set each race-start timer to any whole-minute value from 1 to 15 minutes.
Note:
When the instrument is first installed, the race-start timers are set to 4 and 5 min-
utes respectively.
To set a race-start timer:
1. Use the
timer
key as shown in the
Using timer key
flow diagram to select the
required race-start timer.
2. Simultaneously press the
timer
and
reset
keys to enter the race-start timer
adjust mode.
3. Use either the
timer
or
reset
key to set the required value.
4. Simultaneously press the
timer
and
reset
keys to save the value and leave
the race-start timer adjust mode.
If you are using one of the race-start timers and the timer buzzer is enabled, the
buzzer will:
• Double-beep every minute.
• Beep three times at the start of the last 30 seconds.
• Beep once for each of the last 10 seconds.
• Beep for 2 seconds at zero.
The timer buzzer is enabled or disabled as part of the calibration procedure (see
Chapter 4, Calibration
).
Note:
After a race-start timer has counted-down to zero, it will then start counting up.
1.3 Display settings
Illumination
When the instrument is first powered up, the display illumination is set to its
lowest (courtesy) level to facilitate initial access to the keys. To adjust the level of
illumination:
1. Hold down the speed key for approximately one second, to enter the illumina-
tion-adjust mode.