Ripmax WotsWot XL Instructions Manual - page 10
WotsWot XL Instructions | WotsWot XL Anleitung
10
Stage 36 / Schritt 36
Stage 39 / Schritt 39
Stage 37 / Schritt 37
Stage 38 / Schritt 38
Stage 40 / Schritt 40
Slide the tailplane into its pre-cut slot in the rear of the
fuselage. Ensure that it is square to the fuselage, level against
the wings and centred in its slot using a long ruler or string
as shown in the diagram on the right. Install the fin and
then mark the tailplane on the top and
bottom where it enters the fuselage
using a soft, water-soluble pen. Repeat
for the fin as shown.
Remove the film between the cut lines of the tailplane, on
both bottom and top surfaces. Repeat this process of the lower
section of the fin, below the cut lines.
Slide the tailplane into place and check alignment - once
happy run thin cyano glue along the edge of the tailplane/
fuselage joint. Ensure that adequate glue is used, but do not use
too much, which can result in runs. Allow to cure then repeat for
the underside of the tailplane/fuselage joint.
With the covering removed, the fin and tailplane are ready to
be installed. If necessary, use a warm covering iron to ensure the
edges of the film are firmly adhered.
Smear a generous amount of epoxy inside the slot for the fin
& on the base of the fin so that it will glue firmly to the upper
surface of the tailplane.
Schieben Sie das Heckleitwerk in den
ausgeschnittenen Schlitz an der Rückseite des Rumpfes.
Stellen Sie sicher, dass dieses im rechten Winkel zum Rumpf
steht, und mittig in den Schlitzen sitzt. Verwenden Sie ein langes Lineal, oder eine Schnur, wie in dem Diagramm auf der
rechten Seite gezeigt wird. Markieren Sie mit einem wasserlöslichen Stift das Leitwerk auf der Ober - und Unterseite, wo
es in den Rumpf geht. Wiederholen Sie dies für die Finne, wie gezeigt.
Entfernen Sie die Folie zwischen den Schnittlinien an der
Ober - und Unterseite des Heckleitwerks. Wiederholen Sie diesen
Vorgang an der Schnittlinie am unteren Teil der Finne.
Schieben Sie das Höhenleitwerk in seine Position und
überprüfen ob dieses korrekt ausgerichtet wurde. Wenn Sie mit dem
Sitz zufrieden sind, verwenden Sie dünnflüssigen Sekundenkleber
und verkleben damit die Kanten des Höhenleitwerks mit dem
Rumpf. Nicht zu viel Sekundenkleber verwenden, da dieser heraus laufen kann. Nach dem Aushärten wiederholen Sie
dieses an der Unterseite.
Nachdem die Folie entfernt ist, kann die Finne und das
Höhenleitwerk montiert werden. Wenn nötig verwenden Sie ein
Bügeleisen, damit die Folie an den Rändern haftet.
Mit reichlich Epoxid Kleber bestreichen Sie die Innenseite des
Schlitzes und die Basis (Unterkante) der Finne, so dass Sie diese
fest mit der Oberseite des Höhenleitwerks verkleben können.