Ripmax WotsWot XL Instructions Manual - page 4
WotsWot XL Instructions | WotsWot XL Anleitung
4
Stage 6 / Schritt 6
Stage 9 / Schritt 9
Stage 7 / Schritt 7
Stage 8 / Schritt 8
Stage 10 / Schritt 10
Use the cord to pull the servo extension lead through the wing
panel. Carefully cut away the covering over the servo lead hole
in the upper surface of the wing panel at the root and feed the
extension lead through this hole.
Fit the aileron servo into the wing panel, then use a hole centre
tool or similar to drill the pilot holes for the servo mounting screws.
Screw the aileron servos in position using the mounting
screws, rubber grommets and ferrules supplied with your radio.
Note that the output arms face towards the front of the wing.
Prepare the aileron pushrods by screwing on a metal clevis
and fuel tube keeper. Locate the aileron control horns. They are
screwed in position on the ailerons in line with the aileron servo's
output arm. Align the row of holes in the horn with the hingeline.
Mark and pilot drill two mounting holes.
Screw the horn to the aileron. The screws thread into the
moulded horn plate on the top surface of the wing. Do not
overtighten the control horn mounting screws - you don't want
to crush the aileron. Turn the model over and trim off any excess
thread using side cutters.
Mit einem scharfen Messer schneiden Sie vorsichtig die Folie
über den Servokabel Löchern, an der Oberseite der Flügelhälfte,
aus. Durch ziehen am Baumwollfaden ziehen Sie jetzt vorsichtig
die Kabel durch das Loch heraus.
Überprüfen Sie den Sitz ihres Servos in der Einbauöffnung,
und bohren dann die Löcher für die Befestigungsschrauben.
Schrauben Sie die Querruder Servos mit den
Montageschrauben, Gummiblöcke und Messinghülsen, die mit
Ihrer Fernsteuerung mitgeliefert wurden, in Position. Beachten Sie
dabei, dass der Servoabtrieb zur Flügelvorderseite zeigt.
Befestigen Sie am Querrudergestänge ein Metallgabelkopf
und eine Sicherung aus Kraftstoffschlauch. Nehmen Sie
die Querruderhörner. Diese werden in einer Linie mit den
Servoabtrieben auf den Querrudern festgeschraubt. Richten Sie
die Löcher im Ruderhorn mit der Scharnierlinie aus. Markieren
und bohren Sie zwei Löcher.
Schrauben Sie das Querruderhorn an seine Position. Die
Schrauben werden in die Trägerplatte auf der Oberseite des
Ruders eingeschraubt. Nicht die Ruderhornschrauben überdrehen
- Sie möchten ja nicht das Querruder zerdrücken. Drehen Sie das
Modell um, und schneiden das überschüssige Gewinde mit einem
Seitenschneider ab.