Ripmax WotsWot XL Instructions Manual - page 16
WotsWot XL Instructions | WotsWot XL Anleitung
16
Stage 66 / Schritt 66
Stage 69 / Schritt 69
Stage 67 / Schritt 67
Stage 68 / Schritt 68
Stage 70 / Schritt 70
Pilot drill the cowl and retain with four self tapping screws,
two on each side of the model.
It is recommended that the screws are fully tightened and that
then they and the cowling are removed, after which thin cyano
can be run into the holes to harden the wood. Allow the cyano to
fully cure before refitting the cowling.
Depending on the crankshaft diameter of the engine being
used it may be necessary to fit the insert into the backplate to
obtain a good fit.
Fit the propeller and spinner to complete the engine and
cowling installation.
Fits switches - the radio and ignition switches can be installed
on opposite sides of the fuselage.
Bohren Sie die Löcher vor und schrauben die Motorhaube mit
den 4 selbstschneiden Schrauben fest. Zwei auf jeder Seite des
Modells.
Wir empfehlen Ihnen die Schrauben vollständig anzuziehen,
und dann wieder zu lösen. Danach entfernen Sie die
Motorhaube und geben etwas dünnflüssigen Sekundenkleber
in die Bohrlöcher, um das Holz zu verstärken. Lassen Sie den
Sekundenkleber vollständig aushärten bevor Sie die Motorhaube
wieder montieren.
Abhängig vom Durchmesser der Kurbelwelle Ihres Motors,
kann es sein, dass Sie den Einsatz (siehe Bild), für einen guten Sitz
in der Schwungscheibe montieren müssen.
Befestigen Sie den Propeller und Spinner um den Motoreinbau
und die Montage der Motorhaube zu vervollständigen.
Montieren Sie Ihre Ein- und Ausschalter für Empfänger und
Zündung an der gegenüberliegende Rumpfseite.