Ripmax WotsWot XL Instructions Manual - page 15
WotsWot XL Instructions | WotsWot XL Anleitung
15
Stage 61 / Schritt 61
Stage 64 / Schritt 64
Stage 62 / Schritt 62
Stage 63 / Schritt 63
Stage 65 / Schritt 65
Fit engine to the stand-offs and mount the silencer - use
threadlock compound on all bolts.
A large allen driver or similar can be used to both tighten the
stand-offs and to lock them in place whilst the engine mounting
bolts are tightened.
Mark the front former with the positions of the holes required
for the throttle and choke linkages, then remove the engine
and drill these holes, opening them up as required to allow free
movement of the linkages.
Trim the fibreglass cowl to clear the engine and silencer. The
cowl should just overlap the front of the fuselage.
Carefully measure the positions of the cowl mounting blocks
and transfer these measurements onto the cowl.
Montieren Sie den Motor auf den Abstandshaltern und
befestigen den Schalldämpfer. Verwenden Sie für alle Schrauben
Sicherungslack.
Mit einem großen Innensechskantschlüssel können Sie beides
machen. Die Abstandshalter festschrauben, wie auch diese an
ihrem Platz zu sichern, während Sie die Motorhalteschrauben
festziehen.
Markieren Sie die Positionslöcher an der Frontplatte für die
Gas- und Choke Anlenkungen. Danach entfernen Sie den Motor
und bohren die Löcher. Bearbeiten Sie die Löcher, damit die
Gestänge frei beweglich sind.
Schneiden Sie die GFK Motorhaube aus, um Platz für den
Zylinderkopf und den Schalldämpfer zu schaffen. Die Motorhaube
sollte den Rumpf überlappen.
Messen Sie die Position der Befestigungsblöcke der
Motorhaube aus, und übertragen die Maße auf die Motorhaube.