Ripmax WotsWot XL Instructions Manual - page 17
WotsWot XL Instructions | WotsWot XL Anleitung
17
Stage 71 / Schritt 71
Stage 74 / Schritt 74
Stage 72 / Schritt 72
Stage 73 / Schritt 73
Stage 75 / Schritt 75
Fit the throttle and choke servos to the radio plate as shown.
Install the servo adapters onto the servo arms for both the
throttle and choke servos. A drop of cyano on the protruding end
of the threaded section will ensure that the nut does not loosen
due to vibration.
Complete the internal installation with the fitment of the
equipment tray, which holds the throttle and choke servos as well
as the receiver and electronic ignition unit. Connect the throttle
and choke linkages to the servo arms. The receiver is mounted
using multiple layers of servo tape to provide a degree of vibration
absorption. Position the receiver aerials as detailed in your radio
instruction manual.
Check the fit of the pilot figure and then glue into place.
Ensure that the pilot is positioned correctly so that the canopy can
be fitted into its correct position.
The pre-trimmed canopy is supplied ready to fit using your
favourite method. The kit is supplied with four screws to retain the
canopy, or you can use canopy glue (or a combination of both) if
you prefer. If using canopy glue, carefully apply to the perimeter
of the canopy and hold it place with strips of tape until the glue
dries.
Montieren Sie das Gas- und Choke Servo auf der Radioplatte,
wie gezeigt.
Installieren Sie die Servo Adapter an den Servoarmen
sowohl für das Gas und Choke Servo. Geben Sie einen Tropfen
Sekundenkleber auf das überstehende Ende des Gewindes. Dies
stellt sicher, dass sich bei Vibrationen die Mutter nicht lösen kann.
Vervollständigen Sie die interne Installation mit dem Zubehörteil
des Gerätefaches. Dies hält das Gas- und Choke Servo, wie auch
Empfänger und Zündung an ihrem Platz. Verbinden Sie das Gas-
und Choke Gestänge mit dem Servoarm. Um die Vibrationen zu
dämpfen, wird der Empfänger mit mehreren Schichten Servoband
umwickelt und montiert. Befestigen Sie die Empfängerantennen, wie dies in der Fernsteuerungsanleitung beschrieben ist.
Überprüfen Sie den Sitz der Pilotenfigur und kleben diese an
ihren Platz. Vergewissern Sie sich, dass der Pilot richtig positioniert
wurde, damit Sie die Kabinenhaube an ihrem Platz befestigen
können.
Die Kabinenhaube wird einbaufertig geliefert. Es werden
4 Schrauben für die Montage der Kabinenhaube mitgeliefert.
Sie können die Kabinenhaube auch einkleben (oder eine
Kombination aus beidem). Wenn Sie diese mit Kleber befestigen,
achten Sie darauf, dass Sie den Kleber nur entlang des Randes
der Kabinenhaube auftragen. Mit ein paar Klebestreifen fixieren Sie diese an ihren Platz, bis der Klebstoff ausgehärtet ist.