Ripmax WotsWot XL Instructions Manual - page 8
WotsWot XL Instructions | WotsWot XL Anleitung
8
Stage 26 / Schritt 26
Stage 29 / Schritt 29
Stage 27 / Schritt 27
Stage 28 / Schritt 28
Stage 30 / Schritt 30
Carefully cut away the covering over the upper wing mount
slot in the fuselage.
Slide the upper wing mount into place and use a soft, water
soluble pen to draw around the wing mount where it fits the
fuselage.
Remove the upper wing mount from the fuselage and carefully
cut through the covering film just under the drawn line.
Remove the covering film around the lower section of the
upper wing mount as shown.
Thread the two bolts supplied, complete with washers into the
upper wing mount, and tighten securely. Use threadlock.
Mit einem scharfen Messer entfernen Sie die Folie über dem
Schlitz der oberen Flügelbefestigung am Rumpf.
Schieben Sie die obere Flügelhalterung an ihren Platz.
Markieren Sie mit einem wasserlöslichen Stift die Flügelhalterung,
wo diese im Rumpf sitzt.
Nehmen Sie die Flügelhalterung heraus, und schneiden die
Folie direkt unterhalb der markierten Linie mit einem Messer ab.
Entfernen Sie die Folie am unteren Abschnitt der
Flügelhalterung, wie gezeigt.
Befestigen Sie die beiden Schrauben mit den Unterlegscheiben
an der oberen Flügelhalterung und ziehen diese fest. Verwenden
Sie Sicherungslack.