SmartVent Synergy 190 User Manual - page 28
25
There are 2 settings available for FAN
MIN
f
FAN OFF - Fan switches off until
the room temperature rises above
the Minimum Temperature setting.
f
LOW SPEED - Changes fans
to Low Speed when the room
temperature falls below Minimum
Temperature setting.
FAN MIN
Use this to set the ventilation rate
of the system, when Min Temp is
reached in the controller room.
FAN MIN controls the operation of
the fans when the Room Temperature
falls below the system Minimum
Temperature setting.
The default setting for FAN MIN when
installed is Enabled; low speed.
When you press the FAN MIN tab the
FAN MIN page will display
Once the setting has been entered,
Press the Home button to return
to the Home Page or
Press the Back button to step
back to the SETTINGS Menu.
If any changes have been made to the
settings in this section, Synergy will
prompt you to confi rm your decision.
Refer to page 20 for further instructions
Once the setting has been entered,
Press the Home button to return
to the Home Page or
Press the Back button to step
back to the SETTINGS Menu.
If any changes have been made to the
settings in this section, Synergy will
prompt you to confi rm your decision.
Refer to page 20 for further instructions