SmartVent Synergy 190 User Manual - page 31

28

Press the Home button to return 

to the Home Page at any time.

Press the Back button to step 

back to the SETTINGS Menu.

Once Heat Boost is enabled, you will 

need to set your Boost Temp (page 32).

If installed, the HEAT BOOST page will 

appear. 

The HEAT BOOST button is used 

to enable or disable the Heat Boost 

function.

The BOOST  TEMP button is used to set 

the temperature level in the controller 

room at which you would like the 

system to extract excess heat only from 

the heat source room.

NORMAL HEAT BOOST MODE

Normal mode is driven by the BOOST  

TEMP setting.  If the Heat Boost is 

enabled and this mode is active, then it 

will automatically turn the Heat Boost 

ON when your Control Room rises above 

the BOOST  TEMP and off again when it 

drops 1

o

C below the BOOST  TEMP.

The Normal tab border is highlighted 

blue indicating this mode is active:

Note:

Normal mode is the default mode. Synergy will 

automatically select this mode when the Heat 

Boost is turned ON, providing neither of the 

other two modes were active prior to the Heat 

Boost being turned OFF.

If a different mode is active and you 

wish to enable Normal mode, press the 

Normal tab: