SmartVent Synergy 190 User Manual - page 44

41

Maintenance

To Reset your Filters once maintenance is complete 

The Filter resets are to be used when you have cleaned or replaced your filter/s 

and wish to reset the filter/s back to empty/new. This will reset the replacement 

time back to the start. Please refer to page 14

G3 FILTER MAINTENANCE

The G3 filter’s life span for Smart-Vent Synergy is approximately 1/2 year (26 weeks) 

before reaching 100% filter usage/ FULL. 

There are two G3 filters situated in the Heat Exchanger. Once the G3 filters are FULL 

you will need to clean the filter media by completing the following steps:

1)  Turn your Synergy system OFF (refer to page 8 for instructions on turning your 

system OFF). Wait until the fans come to a complete stop before moving on to the 

next step 

2)  Remove the front panel (black 

plastic cover) from the Heat 

Exchanger

3)  Carefully remove the two filter 

access covers.

4)  Locate and carefully remove the 2 

x G3 filters as pictured:

5)  Gently clean the outside of the 

filters with a vacuum as shown

6)  After cleaning, carefully replace the filters inside the heat exchanger.

7)  Replace the filter cover and front panel

8)  Turn your Synergy system back ON (refer to page 9

for instructions on turning 

your system ON).

Note:  

After 2 or 3 years you may find the filters are not cleaning as well as they used to.  If after cleaning 

they are still dirty you should consider replacing them.  Replacement G3 filters are available - please 

contact Securimax for ordering information.

Front Panel 

Filter access covers 

Filters