SmartVent Synergy 190 User Manual - page 37
34
The CORE BY-PASS page will display the
status of the Core By-pass mode. If this
mode is ON then the ON button border
will be highlighted and the 3 arrows are
coloured blue:
To disable the Core By-Pass mode press
the OFF button and the page changes so
that the OFF button is highlighted blue
and the arrows are coloured white.
Note:
As a safety feature, if the inlet air falls below
-5°C, the Core By-Pass damper opens to prevent
the condensation in the Heat Exchanger core
icing up.
Press the Home button to return
to the Home Page at any time.
Press the Back button to step
back to the SETTINGS Menu.
If installed, the CORE BY-PASS page will
appear.
Once the setting has been entered,
Press the Home button to return
to the Home Page or
Press the Back button to step
back to the SETTINGS Menu.
If any changes have been made to the
settings in this section, Synergy will
prompt you to confi rm your decision.
Refer to page 20 for further instructions