SmartVent Synergy 190 User Manual - page 33
30
The TIMER page is displayed showing
Timer 1 and Timer 2 on/off times:
Two timers allow morning and evening
operations but there are no restrictions
of the timer band width or even overlap.
To enable the Timer Heat Boost mode
press the Timer tab:
TIMER HEAT BOOST MODE
Timer Mode is a combination of time
intervals which are conditional on the
room temperature rising above the
BOOST TEMP settings.
For the HEAT BOOST to turn ON in Timer
mode, two conditions must be met:
1) The time of day must fall within
either of the 2 set time periods as
set by you.
2) The temperature in the control room
must be higher than the BOOST TEMP
setting.
To set the Timer(s)
To turn Timer 1 ON, press the button
adjacent to the Timer 1 tab labelled ‘OFF’.
This will change to an ON button with a
red border:
Use the arrows to adjust the time
in hours and minutes that the Heat
Boost will turn on, provided the room
temperature is higher than BOOST
TEMP setting. The arrows on the left
hand side of the Timer 1 ‘clock box’
adjust the Hour, and the ones on the
right hand side adjust the Minutes.
If two timer periods are required, repeat
the procedure for Timer 2. Both or either
timers can be on or off.
As an example the Heat Boost could be
set to come on between 6am and 8am
in the morning and between 5pm and
8pm at night, all provided the room
temperature is higher than BOOST
TEMP.
Note:
1. If your room temperature is below your
BOOST TEMP setting during your timer
periods, then the Heat Boost will not turn ON.
2. If your room temperature rises above your
BOOST TEMP outside of your chosen time
periods, then the HEAT BOOST will NOT
turn ON.
Return to the HEAT BOOST page
by pressing the Back button