Tait TP9300 User Manual - page 38
38 Before using your radio
Installing an audio accessory
Warning
Use only Tait-supplied, IS and NI-approved
audio accessories with IS and NI radios. Fitting an
audio accessory that is not IS-approved exposes the
customer to a risk of explosion which could cause
serious injury or death. For an up-to-date list of
approved audio accessories, contact your regional
Tait office. For detailed information about IS and NI
radios and how to identify them, see
and Non-Incendive radios and accessories" on
.
Audio accessories plug into the radio’s accessory
connector. The accessory connector is protected by a
cover, which needs to be removed before an
accessory can be installed.
Notice
The accessory cover protects the accessory
connector from electrostatic discharge. Keep the
cover in place unless the connector is in use.
To remove the accessory cover and install an audio
accessory:
1
Use a coin or other blunt object to loosen the screw
that secures the accessory cover to the radio.
2
Remove the accessory cover and store it in a safe
place.
3
Plug the accessory into the accessory connector.
4
Tighten the screw.