Tait TP9300 User Manual - Scanning A Group of Channels

90  Operating in conventional mode

This channel is known as the ‘home’ channel, and will 

be the channel you make and receive calls on. While 

voting is active, the orange LED glows and the 

scanning icon 

 appears on the display.

The section 

"Selecting a group" on page 73

 explains 

how to select a group. A group can be either a voting 

or a scanning group.

Suspending a channel from a voting group

You may be able to use the function key programmed 

for nuisance delete to temporarily delete one of the 

channels from the voting group. 

When that voting group is next selected, or after the 

radio has been turned off and then on, the deleted 

channel is again part of the voting group.

Alternatively, the function key programmed for voting 

may be programmed so that a short key press turns 

on voting, and a long key press activates nuisance 

delete.

■

Press and hold the function key programmed for 

voting to remove the current channel from the vot-

ing group.

If the operation has been successful, the message 

Channel nuisance deleted 

appears on the 

display.

Scanning a group of channels

The scan function is used to monitor a programmed 

group of channels, looking for activity. While the radio 

is scanning for activity, the orange LED glows and the 

scanning icon 

 appears on the display. When 

activity is detected on a channel in the scan group, the 

radio stops on that channel. The orange LED begins 

flashing, the radio unmutes and you can hear the call. 

Scanning resumes once the channel is no longer 

busy.