Tascam DM-3200 Release Notes - Dm-3200 Release Notes
DM-3200 Release Notes
18
TASCAM DM-3200 Release Notes
Version 1.30
Version 1.50
ª
Version 1.50 Remote control
Previously, the LCD would unexpectedly switch focus
when both MIDI Faders and the DAW Control Surface
feature was being used and the master fader touched.
This has been fixed.
ª
Change in the date information for
Project Property
The
PROJECT
Property shows date information, but in
previous versions this was the date of creation. This has
been fixed so that the most recently edited date and time
are shown.
ª
CF cards
A problem has been fixed that had caused the capacity to
be shown incorrectly for CF cards larger than 1G byte.
A problem has been fixed that had caused the status of a
CF card to be sometimes detected incorrectly when the CF
was formatted at start-up.
A problem has been fixed that had caused the status of a
CF card formatted on Windows XP or Mac OS 10.4.3 to be
detected incorrectly
ª
Project
Create project
A problem has been fixed which had sometimes made it
impossible to create a new project after the current project
name was edited.
Load project
A problem has been fixed in which the LED indicating the
selected control room source was displayed incorrectly
when a project was loaded.
A problem has been fixed in which the cascade connection
status sometimes became invalid when loading a project
that changed the cascade master/slave relationship.
ª
Version 1.30 Remote control
Ch 9-16 screen text display when using Sonar4
A problem has been fixed in which the text display for each
module was not shown in the channel 9-16 screen when
using Sonar 4 in the Mackie Control mode.
Stereo fader operation using Mackie protocol
and another external controller
When the Mackie Control External Controller was used in
conjunction with another External Controller that used the
remote fader bank, moving the master fader would operate
the Mackie Control master fader function even when the
fader bank was currently assigned to the other controller.
This has been fixed.
MMC CHASE command
The MMC machine control CHASE command is now
supported.
In setups in which P2 protocol is used to control a VTR or
other device, and the recorder is the time-code slave, the
recorder can be set to MMC control to allow recording on
the recorder.
Fig 20: machine_P2mmc.png
DTRS REC function setting in P2
A problem has been fixed in which it had been impossible
to set the REC function for track 9 or higher when using
P2 to control DTRS.
MX-2424 REC function setting via MMC
A problem has been fixed in which the REC function could
not be set correctly when controlling the MX-2424 via MMC.
ª
Switching of BUSS PAN Follows ST PAN
during automation is now disabled
Switching the BUSS PAN Follows ST PAN on/off while
automation is operating has now been disabled. If you
attempt to switch this while automation is operating, a
popup message will appear, and the change will not be
accepted.
Popup message:
Cannot do this
while automatio is running.
ª
Slave Lock processing when cascade
connection is cancelled
A UI improvement has been made so that when you cancel
the cascade connection, the clock master of the slave
device is set to Internal. When you attempt to cancel the
cascade connection, the following popup message will
appear.
Popup message: