Tascam DM-3200 Release Notes - Dm-3200 Release Notes
DM-3200 Release Notes
6
TASCAM DM-3200 Release Notes
Version 1.30
ª
IF-FW MKII support
TDIF Hi-Speed support
When operating at a high sampling rate (88.1k/96kHz),
the high speed mode of
TDIF-1
connectors 1-3 and the
separately sold IF-TD/DM option card are now supported.
Even when operating at a high sampling rate, one
TDIF-1
connector can transfer eight channels of digital audio I/O,
and when the IF-TD/DM is used in conjunction with the
X-48, a maximum of forty channels of digital audio I/O
can be transferred.
TDIF-1 1-3
•
Figure 6 DIGITAL>FORMAT screen
In the
DIGITAL>FORMAT
screen
TDIF I/O Tx/Rx MODE
section, you can now switch between high speed and dual
line for
TDIF-1
connectors 1-3. This selection will switch
all three of the
TDIF-1
connectors.
When using high speed operation, the 8 I/O setting will
be available for TDIF input/output in the
ROUTING
screen;
when using dual line, only the 4 I/O setting will be available.
IF-TD/DM
•
Figure 7 DIGITAL>SLOT screen
An indication of HI-SPEED is shown in the TDIF-1 Card
screen of the
DIGITAL>SLOT
screen.
IF-TD/DM supports only high speed; it does not support
dual line.
ª
MIDI
MIDI control change message support for
mixer parameters
MIDI control change messages are now supported, allow-
ing mixer parameters (
FADER
,
PAN
, and
MUTE
) to be
controlled.
This allows MIDI devices to be controlled in synchroniza-
tion with operations on the DM-3200 mixer, or conversely
for mixer parameters to be controlled from a MIDI device.
In the
MIDI>CtrlChg MIX
. screen, the
CONTROL CHANGE TABLE
FOR MIXER
allows you to assign control change numbers.
Figure 8 MIDI>CtrlChg MIX screen
By using
BATCH SETUP
you can make settings for all
sixteen channels at once.
MIDI>SETUP screen filtering
In conjunction with MIDI control change support for mixer
parameters, filtering has been added to the USB MIDI 4:
PC/CC port.
Figure 9 MIDI>SETUP screen
Until now, the input/output on/off setting for USB MIDI port
3 (used for MIDI time code) had been a single setting for
input and out put, but these can now be set independently.