V2 VEGA-24V User Manual - page 45
E
N
G
L
IS
H
43
9.
By keeping the door closed, weld the tube base to the
g 2
lower part free end of the telescopic arm
10.
Enter and finally fasten the telescopic arm on the
anchoring bracket by fastening all pins by means of
“seeger” supplied
11.
Fasten the bracket, which has been previously
entered into the tube, to the sliding door
12.
Repeat what described at points 3 ÷ 11 as for the
other side of the door
13.
Release the ratiomotor and check that the sliding
door opening and closing operations can be easily
performed.
Otherwise, the door must be balanced again by
increasing the balance weights.
m
WARNING: If the motor is installed on the
upper leaf of a double-leaf up-and-over door, the
motors and limit switch connectors will have to be
inverted to restore the appropriate running
direction.