Vallox 096 MV Manual - Mounting On The Wall
57
© Vallox Oy - All rights reserved
INS
TALLA
TION
MOUNTING ON THE WALL
NOTE
• Avoid mounting the unit on a hollow, echoing partition wall or on a
bedroom wall, or prevent the conduction of sound.
• The minimum distance between the top of the unit and the finished
ceiling surface is 30 mm. Note that during mounting the unit rises 10
mm higher than the final height.
Mount the ventilation unit on the wall with a mounting plate, as shown
in the adjacent figure. Make sure that the unit is horizontally level after
mounting.
MOUNTING ON THE CEILING
Model Vallox 90 MV can be equipped with an optional ceiling mount
plate. To attach the ceiling mounting plate:
• To the ceiling with M8 thread bars so that they stand the weight of the unit.
• Horizontally, because the levelness of the ceiling mounting plate
determines the levelness of the unit.
• There is a 6 mm space between the rear edge of the ceiling
mounting plate and the wall.
• The minimum distance between the bottom surface of the ceiling
mounting plate and the false ceiling is 14 mm. When this minimum
distance is used, the distance between the top of the unit mounted
on the ceiling mounting plate and the ceiling is around 2 mm.
Insulate the outdoor air and exhaust air duct against condensation also
between the unit and the ceiling mounting plate.
Mounting the ceiling mounting plate
1. Attach the M8 thread bars to the ceiling and turn the nuts (A) to the bars.
2. Shorten the lower ends of the thread bars so that they will be at no
more than 25mm from the lower surface of the ceiling mounting
plate. Thread bars can be shortened only before the ceiling
mounting plate is installed.
3. Lift the ceiling mounting plate in place.
4. Push a rubber damper (B) and a washer (C) onto each thread bar, and
ensure that they touch the bottom of the cups of the plate.
5. Turn the nuts to make sure that the unit is horizontally level. Lastly,
fasten the screws.
1
2
A-A
A
A
m
ax
.2
5
min. 14
2
1
6mm
A
B
C
D
M8