Valor 807 Installer And Owner Manual - Bulb Shroud.
spacer frame is removed.
3.
Remove the spacer frame.
4.
Drill appropriate sized holes in the marked
position.
5.
Insert a wallplug into the drilled holes.
6.
Place the spacer frame so that the holes in the
brackets are in line with the wallplugs in the
fixing surface. If the electric cable is to go to
the left or right of the heater then stand the
heater in front of the spacer frame. Pass the
electrical cable underneath the spacer frame and
locate it into the cutout in the centre of
the spacer frame (See figure 8).
7.
Screw and secure the spacer frame
with three ‘H’ screws (See figure 15).
8.
Place the heater centrally against the
spacer frame. The heater has holes in its
left side, right side and top. Secure the
heater to the spacer frame through the
four hole positions as in figure 9 using
four ‘I’ screws (See figure 15).
Setting the position of the Light
bulb shroud.
What is the light bulb shroud?
The light bulb shroud (See figure 10) is
the coloured tube that sits around the light bulb.
What is it for?
The light bulb shroud can be rotated to give different
light effects. If you look at the light bulb shroud you
will see a dark area. This dark area is there to reduce
the amount of light from the light bulb to the areas
which it faces. The slots are there to give a white or
brighter light.
Page 10
INSTALLER AND OWNER GUIDE
Figure 10. Shroud rotation
Figure 9. Fixing the Heater to the
spacer frame.
Figure 8. Locating the electric cable
into the spacer frame.