Valor 807 Installer And Owner Manual - Moving The Cable Guide
Moving the Cable Guide
At the base of the heater you will find an electric
cable which runs through a rectangular plastic cable
guide. As supplied the cable guide is fitted into the
rectangular cutout on the right side of the heater. If
required, the cable guide can be removed and put in
the rectangular slot in the centre or left hand side of
the heater. For removal and fitting please see below.
Removing the cable guide
1.
Before removing the cable guide please note that
the wider part of the cable guide is on the outer edge
of the base (See figure 1- Item 1).
2.
To remove the cable guide push and lift the tab on
the bottom of the cable guide. The bottom of the
cable guide will open (See figure 1- Item 2).
3.
Lift the electric cable clear of the cable guide.
4.
Hold the bottom of the cable guide close to the
heater then gently pull the cable guide away from
the rectangular slot (See figure 1- Item 3).
Fitting the cable guide.
When fitting the cable guide please remember that
the wider part of the cable guide has to be fitted
against the outer edge of the base (See figure 1- Item
1).
1. Gently pinch the sides of the cable guide (See
figure 1 - Item 4) and push the cable guide into the
required rectangular slot.
2. Place the electrical cable into the guide and close
the top of the cable guide.
If the mains cable is damaged, to avoid a hazard it
must be replaced by a Valor authorised service agent,
or similarly qualified person (See the last page of
this guide for useful telephone numbers).
All external wiring between the heater and the electrical supply shall comply with
current IEE regulations.
Page 6
INSTALLER AND OWNER GUIDE
Figure 1. Removing and
positioning the cable guide.
Item 1
Item 2
Item 3
Item 4