Valor 807 Installer And Owner Manual - Fitting The Heater
cleaning, maintenance or replacing the light bulb.
!
Always
make sure the heater is firmly secured to prevent it from being tipped over.
!
Always
use a fireguard when young children and infirm persons can come into
contact with the heater.
!
Always
use genuine Valor spares.
Never
!
Never
leave children unsupervised in a room where the heater is ON and
unguarded.
!
Never
obstruct or cover the fan outlet or force items into heater openings.
!
Never
install or use the heater anywhere where water is in use, i.e.
Bathrooms, Kitchens, Shower Rooms, Swimming Pools etc.
!
Never
use aerosols or steam cleaners on or around the heater.
!
Never
route the mains supply cable under carpet etc.
!
Never
install the heater close to curtains or combustible materials.
!
Never
use the heater to dry clothes etc.
!
Never
sit or stand on the heater.
FITTING THE HEATER
The installation of this heater requires a reasonable level of DIY skills.
Please read this guide thoroughly before commencing installation and if in doubt,
seek help from a competent person
Do I need any tools?
1. You will need two screwdrivers: -
1 off Pozidrive / Phillips / cross head
screwdriver. This should have a number 2 size
end. If you are unsure about the size of the end simply make sure that the end fits into
the screws supplied with the heater. If the end is too small then the end will spin and
damage the screw.
1 off Flat end
screwdriver. The end should fit into the slot head screws supplied with
the heater.
2. For drilling into brickwork you will need an electric hammer drill and appropriate
size drill bit for the wallplugs supplied (See figure 15).
Page 4
INSTALLER AND OWNER GUIDE