Valor 807 Installer And Owner Manual - Heater)
side of the heater. Continue to push the
wire through this hole until there is only a
small loop of wire at the front of the
heater (See figure 6 - item 3).
9.
At the back of the heater there will be a
long piece and a short piece of wire
coming through the two holes. Hold the
short piece and give the long piece a
gentle tug. This will secure the steel wire.
Take the long piece and thread this
through the eyescrew in the back of the
fireplace opening (See figure 6 - item 4).
10.
From the back of the heater thread the
long piece of steel wire through the outer
small hole on the right hand side of the
heater (See figure 6 - item 5).
11.
Locate the heater in the fireplace
opening, then from the front of the heater,
gently pull the steel wire on the right hand
side to gather up the excess until the
heater is secure. Thread the wire through
the remaining small hole to lock the wire
and heater in place (See figure 6 - item 6).
Method C - Spacer Frame (A spacer
frame is NOT available for the Dream
heater)
1.
There are three ‘L’ shape brackets supplied
with the heater (See figure 15). To fix the
brackets to the spacer frame there are three
‘I’ screws (See figure 15). The spacer frame
has a stepped outer. The rear of the spacer is
the narrow side - when positioned against the
wall or fixing surface the steps should widen
as they come closer to you. Position and
screw the ‘L’ shaped brackets to the rear of
the spacer frame as shown in figure 7.
2.
Position the spacer frame against the wall or front of the opening. Make sure that the
spacer frame is central to the fireplace surround or is in the correct position against the
wall. Mark through the rear holes in the brackets so that their position is clear when the
Page 9
INSTALLER AND OWNER GUIDE
Figure 7. Bracket positions
Figure 6. Steel wire fixing