Valor 807 Installer And Owner Manual - Fitting The Dream Fascia
figure 13)
4.
Place the loose coals onto the fuel support (a glove
is provided with the coal pack). It is not necessary to
use all the coal supplied.
Fitting the Dream Fascia
Note: A certain amount of self-assembly is required
in building up this fascia.
The fixings used can be identified by referring to
figure 15.
Follow the steps below while referring to figure 16.
Unpacking and preparing the Dream Fascia
1.
Open fascia pack, remove the main fascia
and lay it face down on the floor, taking care
no to damage either floor covering or main
fascia. If necessary, flatten the box and lay it
on the floor first.
2.
Place the remaining parts in a safe place.
3.
Place the white top polystyrene packing
piece against a wall. This will prevent the
polystyrene packing piece from moving .
Position the top of the main fascia on top of
the polystyrene packing piece (See figure 14).
Page 12
INSTALLER AND OWNER GUIDE
Figure 15. Loose parts
Figure 14.
Figure 13. Front lower fascia
location. (Shown with the
Victorian fascia - Dream
locates in same way)