Valor 807 Installer And Owner Manual - Removing The Fascia
Removing the fascia
Victorian Heater
1.
Remove the two fascia securing screws (See figure 2).
Remove the front fascia by gently pulling the base of the
fascia forward whilst lifting clear of the support brackets at
the top of the heater (See figure 2).
2.
Keep the fascia in a safe place while installing the heater
Adage Heater.
1.
Very strong magnets attach the fascia to the heater. Support
the rear of the heater and gently pull the fascia forward (See
figure 3).
2.
Keep the fascia in a safe place while installing the heater.
Dream Heater
The fascia is supplied in a separate box within the main box.
Heater Fixing
All of the fixings supplied with the heater have been
identified as in figure 15.
The heater must be fixed into position to prevent it
from being tipped over
The following fixing options are available:
Screw Fixing
Wire Fixing
Spacer Frame (Adage and Victorian heaters only)
If fitting the heater into a fireplace or surround opening,
try the heater in the opening to ensure that it will fit.
If fitting the heater onto a decorative hearth surface such
as marble or tile it is advisable to protect the hearth
surface. Do not drag the heater across the surface of the
hearth as this may scratch the hearth surface.
Page 7
INSTALLER AND OWNER GUIDE
Figure 3. Removal of
Adage fascia.
Figure 2. Removing
Victorian fascia.