Valor 807 Installer And Owner Manual - Shroud?
How will I know which position to set the light bulb shroud?
!
Positioning the dark area of the shroud underneath the light bulb will reduce the
amount of light onto the hearth or floor surface.
!
Positioning the dark area to the rear of the light bulb will reduce the amount of light
to the flame effect at the rear of the heater.
A good start point is to have the light bulb shroud dark area facing the front of the
heater. If the light effect is not to your liking then the lower fascia can be removed and
adjustments made to the shroud after the heater is fitted (On the Adage heater it will be
necessary to remove the whole magnetic front fascia).
How do I set the position of the light bulb
shroud?
Hold the right hand side of the light bulb shroud
and rotate it in a downward direction. Never
rotate the light bulb shroud in an upward
direction as you may be unscrewing the light
bulb at the same time (See figure 10).
Fitting the Adage and Victorian Fascia
Adage Heater
1.
Removing the fascia may have moved the
magnets used to fix the fascia to the heater.
There should be a magnet on each of the four
raised tabs on the rear of the fascia (See figure 11).
2.
Locate the fascia onto the heater. Ensure that the
sides of the fascia sit on the floor / hearth.
3.
Place the loose coals onto the orange coloured
fuel support (a glove is provided with the coal
pack). It is not necessary to use all the coal
supplied.
Victorian Heater
1.
Hook the brackets on the rear of the main fascia
over the brackets on the heater (See figure 12).
2.
Secure with the two screws removed previously
(See figure 1)
3.
Locate the lower fascia onto the main fascia (See
Page 11
INSTALLER AND OWNER GUIDE
Figure 12. Fitting the facia. The
Fascia shown is the ‘Dream’ The
Victorian fits in the same way
Figure 11. Magnet locations