Valor 807 Installer And Owner Manual - Assembling The Dream Fascia
Assembling the Dream Fascia
Step 1.
Locate the hood into the brackets at the top of the casting and secure with 4 off screws
'A' (See figure 14 & 16 - step 1).
Step 2.
Locate the lower brackets onto the fascia and secure with 3 off screws 'B' and 1 off
screw 'C' as in figure 16 - step 2. Ensure the brackets project downward towards the
front face of the main fascia.
Step 3.
1.
Lay the lower fascia face down on a flat surface. Remove the 2 screws holding the
black screen to the rear of the lower fascia. Remove and discard the black screen.
2.
Locate 2 off screws 'F' into the upper two holes in the rear of the lower fascia,
leaving a gap of about 10mm from the underside of the screw head to the rear face of
the casting (See figure 16 - step 3). The 10mm gap is to enable the lower fascia to be
hung onto the main fascia.
3.
Place the orange fuel support onto the rear of lower fascia and secure it in place with
2 off screws 'B' and 2 off large washers 'G '(See figure 16 - step 3).
Fitting the Dream Fascia to the heater.
1.
Fit the main fascia to the heater by hooking the brackets on the rear of the fascia over
the brackets on the heater (See figure 12).
2.
Secure the main fascia to the heater with 2 off screws 'D' and 2 off washers 'E'
through the holes in the lower side legs of the main fascia.
3.
Hook the lower fascia on to the main fascia as in figure 13.
4.
Position the ash pan cover beneath the lower fascia.
5.
Place the loose coals onto the top of the orange fuel support (a glove is provided with
the coal pack). It is not necessary to use all the coal supplied.
Page 14
INSTALLER AND OWNER GUIDE