Vari Lite VL2000 User Manual - Www.Carlosmendoza.Com.Mx
VARI
❋
LITE® - VL2000™ W
ASH
L
UMINAIRE
U
SER
’
S
M
ANUAL
8 6
07-M ay- 03
0 2 . 9 6 7 1 . 0 0 0 1 F
SRCH/FOR/
BRD1
BRD2
Searching for Board 1 or 2
Attmepting to communicate with Board
1 or Board 2. System will return either
OK or an error code.
TILT
ENCR
FAIL
Tilt Encoder Failure
Main board pan/tilt connector (J9)
disconnected
- Connect main board pan/tilt
connector (J9)
Tilt motor disconnected
- Connect tilt motor power
Encoder faulty
- Replace tilt end-of-travel/encoder
sensor assembly
TILT
NO
SENS
Tilt Sensor Not Found
EOT flag attached to large pulley is not
engaging the EOT sensor
- Ensure flag is attached to the large
pulley
- Ensure that flag passes through the
sensor at a depth sufficient to
engage the sensor beam
Tilt belt disconnected, extremely loose
or not installed properly
- Properly install belt between tilt
motor and large pulley
TILT
SENS
ACTV
Tilt Sensor Always Active
Main board pan/tilt connector (J9)
disconnected
- Connect main board pan/tilt
connector (J9)
End-of-travel sensor connector (J2)
disconnected
- Connect end-of-travel sensor
connector (J2)
WAIT
Retrieving Current Status
System displays wait while getting
status.
WRNG
SW
PROG
Wrong Software Program
Software installed does not match
luminaire type
- Download the correct software for
the luminaire
Table A-2: Troubleshooting Guide (Continued)
Error Display
Description
Possible Cause and Remedy