WAGNER Plast Coat 25 Operating Manual - Plast Coat 25 · 35
39
Plast Coat 25 · 35
GB
9
FIttING ACCeSSORIeS
9.1
COMPReSSOR
V 400 suction volume 360 l/min
• Attachcompressorholder(item1,fig.17)andsecurewith
star grip (2).
• Placecompressorontoholder.Slideretainingplate(3)over
the compressor base.
• Securethecompressorwithstargrips(4).
technical data
Roller length: 465 mm
Roller diameter: 66 mm
Weight: 6.7 kg
Putting sack mangle into operation
• Connectcrankhandle(1,fig.18)andsecurewithlinchpin.
• Insertsackmangleandslidingcover(2,accessory).
• Screwoutstargrips(3)about2cm.
• Placesackmangleandcrankhandle(1)ontheslidingcover
to the right from the front. Move guide rollers (4) over stop
pins on the underside of the sliding cover.
• Adjustpressureforceoftheroller(5).Turnthestargrips(3)
to the right until they will go no further.
• Turncrankandmovesackmangletotherearasfarasitwill
go.
material delivery rate and air delivery rate.
fine texture
––> larger air delivery rate
coarse texture
––> low air delivery rate
Higher material
delivery rate
––> higher air delivery rate
We recommend that you test the required texture on a sample
surface.
To improve the „feathering effect“ in order to allow easier over-
lap, choose an appropriate distance between the spray lance
and the object surface.
The spray margin should „feather out“ to allow easier overlap-
ping.
Considerably less spray mist is produced if the spray lance is
always guided at 90° parallel to the spray surface.
Note:
Sharp-edged grains and pigments will increase wear on the
pump, hose, material ball valve and tip.
danger of crushing.
do not pace hands under the roller.
9.2
SACk MANGle
Safety note
fIttIng accessorIes
3
2
1
4
4
1
5
2
3