WAGNER Plast Coat 25 Operating Manual - Plast Coat 25 · 35
41
Plast Coat 25 · 35
GB
10.2
CleANING deVICe ANd CHANGING PuMP
jACket
Never remove the safety grill for any clea-
ning work!
disassembly
• Lubricatepump.
Turn changeover switch to
(backwards).
Spray pump antiseize or a little dishwashing liquid into the
outlet unit (2, fig. 22) or place a little dishwashing liquid into
the receptacle and pump through the pump.
• Turnchangeoverswitchto„0“.
• Unscrewstargrips(1,fig.20).
• Removeoutletunit(2)towardsthefront.
• Setfeedrateto„3“.
• Turnchangeoverswitchto
(forwards).
danger of crushing!
• Pumpjacket(3)willdisconnectfrompumpscrew.
• Setchangeoverswitchto„0“.
• Cleanreceptacleandreceptaclelowersectionwithawater
jet.
When operating using the container suc-
tion system, turn off device using master
switch. Remove the mains plug from the
socket and ensure that it cannot be re-
placed unintentionally.
• Unscrewandremovecontainerconnectionfromtherecep-
tacle lower section.
• Clean receptacle lower section, container connection and
suction hose with a water jet and, if necessary, using a suit-
able brush.
• Cleanpumpscrewandpumpjacketthoroughlywithwater.
• Cleanoutletunit(2)insideusingabottlebrush.
• Keepthreadsforthestargripscleanandgrease.
Pump jacket assembly
Important:
Spray pump screw and pump jacket with pump antiseize or
wet with dishwashing liquid.
• Turnchangeoverswitchto
(backwards).
danger of crushing!
• Placepumpjacket(3,fig.20)ontopumpscrew.Ensurethat
the ledge of the pump jacket (3) is properly slid into the rec-
tangular recess of the pump trigger (4).
• Pumpjacketpullsitselfontothepumpscrew.
• Setchangeoverswitchto“0”.
• Assembleoutletunit.
10.3
CleANING SPRAy lANCe
• Cleantexturenozzle.
• Cleanairholesinthetexturenozzlewithacleaningneedle.
• Cleantheinsideofthespraylancewithabottlebrush.
• Disconnectthemortarhosefromtheoutletsection.
• Insertcleaningballinthemortarhose.
Re-connect the mortar hose.
• Fillwaterintoreceptacle.
When operating using the container suction system, im-
merse suction hose into receptacle with water.
Turn on mortar spraying machine.
• Afterafewsecondsthecleaningballwillcomeoutofthe
spray lance.
• Repeat cleaning procedure 3–4 times, depending on the
coating material used.
There is a further possibility for cleaning using the cleaning
adapter.
This cleaning adapter can be connected to a water hose or
tap with a claw coupling.
Place cleaning ball in the mortar hose. Couple mortar hose to
the cleaning adapter and rinse through with water.
placIng out of operatIon and cleanIng
3
2
1
4