WAGNER Plast Coat 25 Operating Manual - Plast Coat 25 · 35
40
Plast Coat 25 · 35
GB
using coating materials in sacks
• Pullslidingcoverbackabout15cm.
• Placesackontheslidingcoverinsuchawaythatthetop
faces the front end of the sliding cover.
• Cutsackopen.
• Allowthecoatingmaterialtoflowintothereceptacle.
• Move sack mangle forwards over the sack by turning the
crank handle until the guide rollers reach the stop pins.
• Toeasepressing–movesackmangletoframeofsackman-
gle with your left hand.
• Stripremainingcoatingmaterialfromsackopeningwitha
spatula.
9.3
CONtAINeR SuCtION SySteM
• Turnoffdeviceatmasterswitch.
• Pulloutmainsplugfromthesocketandensurethatitcan-
not be plugged back in unintentionally.
• Unscrewthehexagonnuts(2)onthereceptacle(1,Fig.19),
remove washers.
• Removereceptacle.
• Attachcontainerconnection(3)tothebaseoftherecepta-
cle. Mount disks and secure with hexagon nuts (2).
• Connect suction hose (5) to container connection (3). Al-
ternatively, connect connecting bridge (6) to the container
connection (3) and connect suction hose (5) to connecting
bridge.
• Fillsuctionhosewithwaterandconnecttothecontainer.
• Turnonmortarsprayingmachine.
Note:
All connections must be sealed air tight so that a vacuum can
be produced.
Place a small amount of machine lubricant onto the rubber
seals of the connections in order to allow for the easy opening
and closing of the connectors.
10
PlACING Out OF OPeRAtION ANd
CleANING
10.1
CleANING tHe MORtAR HOSe
• Pumpuntilreceptacleisempty.
When operating using the container suction system, remove
suction hose from the container.
Important: do not let the mortar spray machine run
dry.
• Removetexturenozzlefromspraylanceandclean.
do not spray the motor or control unit of
the mortar spraying machine with wa-
ter jet, high-pressure or steam cleaning
equipment. Water could penetrate the ma-
chine and cause a short-circuit.
the mortar hose must be without pres-
sure. If necessary, turn changeover switch
briefly to
(backwards).
Note the pressure gauge ––> 0 bar.
Wear protective goggles.
placIng out of operatIon and cleanIng
5
1
2
3
6
2