Waldorf RN8410G Installation And Operation Manual - page 11

9 

Installation

Clearances 

NOTE:  Only non-combustible materials can be used in close proximity to this appliance. 

*  Side clearances can be 50mm when adjacent surface is at least 100mm below cooking surface. 

Assembly 

NOTE: 

 All Models are delivered completely assembled.  No further assembly is required. 

 This appliance is fitted with adjustable feet to enable appliance to be positioned securely 

and level.  This should be carried out on completion of gas connection.  Refer to ‘Gas 

Connection’ section. 

Optional Accessories (Refer to Replacement Parts List) 

 Rear Roller Kit.  For installation details, refer to instructions supplied with each kit. 

 Plinth Kit.  For installation details, refer to instructions supplied with each kit. 

1. 

Check all feet (or castors) are securely fitted. 

2. 

Adjust feet to make oven range steady and level. 

Gas Connection 

NOTE:  ALL GAS FITTING MUST ONLY BE CARRIED OUT BY AN AUTHORISED PERSON. 

1. 

Waldorf Ranges do not require an electrical connection, as they function totally on gas supply only. 

2. 

It is essential that gas supply is correct for appliance being installed and that adequate supply 

pressure and volume are available.  The following checks should be made before installation:- 

a.  Gas Type the appliance has been supplied for is shown on 

coloured stickers located above gas connection and on 

rating plate.  Check that this is correct for the gas supply 

the appliance is being installed for.  Gas conversion 

procedure is shown in this manual. 

b.  Supply Pressure required for this appliance is shown in 

‘Specifications’ section of this manual.  Check gas supply to 

ensure adequate supply pressure exists. 

c.  Input Rate of this appliance is shown on Rating Plate and 

in ‘Specifications’ section of this manual.  Input rate should 

be checked against available gas supply line capacity.  

Particular note should be taken if appliance is being 

added to an existing installation. 

NOTE:  It is important that adequately sized piping runs directly to connection joint on appliance 

with as few tees and elbows as possible to give maximum supply volume. 

3. 

Fit gas regulator supplied, into gas supply line as close to appliance as possible. 

Fig 1 

Rating Plate 

Location 

This appliance is for professional use and is only to be used by qualified  

persons. 

Only authorised service persons are to carry out installation, servicing or gas 

conversion operations.

Caution 

Combustible Surface 

Non Combustible Surface 

Left / Right hand side 

       250mm (*) 

0mm 

Rear 

50mm 

0mm