Waldorf RN8410G Installation And Operation Manual - page 22

20 

Gas Conversion and Specifications

Griddle 

1. 

Carry out the following:- 

 Remove griddle plate section and heat shield. 

 Remove main burner. 

 Disconnect piezo igniter from mounting 

bracket.  (For access purposes). 

 Disconnect pilot supply tube from pilot burner 

to access pilot injector. 

2. 

With Main Burner removed, ensure aeration gap is adjusted 

for type of gas being used as shown in ‘Gas Specifications 

Tables’ at end of this section. 

3. 

Remove pilot and main injectors and replace with correct size 

injectors as shown in ‘Gas Specifications Tables’ at rear of this 

section. 

4. 

Refit the following:- 

 Re-connect pilot supply tube to pilot burner. 

 Re-connect piezo igniter to mounting bracket. 

 Refit main burner, gas control heat shield and griddle plate to cooktop. 

5. 

Re-light main burners and check flame size on ‘Low’ flame position. 

 Adjust low fire adjustment screw on open burner gas control 

valves to obtain desired flame size. 

NOTE:  The 'Low Fire Screw' should be sealed with coloured paint on 

completion of low fire adjustment. 

Static Oven 

1. 

Carry out the following:- 

 Remove lower lintel at front of oven. 

 Open oven door and remove sole plate(s). 

 Remove main burner. 

 Disconnect pilot supply tube from pilot burner 

to access pilot injector. 

2. 

With Main Burner removed, ensure aeration gap is adjusted 

for type of gas being used as shown in ‘Gas Specifications 

Tables’ at rear of this section. 

Main Burner Injector 

Pilot Supply 

Tube 

Pilot Burner 

Piezo Igniter 

Low Fire Screw 

Burner Adjustment Screw 

Aeration Slide 

Burner Adjustment Screw 

Main Burner 

Main Burner Injector 

Pilot Burner 

Thermocouple 

Aeration Slide