Waldorf RN8410G Installation And Operation Manual - page 23

21 

Gas Conversion and Specifications

NOTE, Pin rotated 

for Natural Gas 

NOTE, Pin rotated 

for LPG 

1. 

Remove pilot and main injectors and replace with correct size injectors as shown in ‘Gas  

Specifications Tables’ at end of this section. 

2. 

Refit the following:- 

 Re-connect pilot supply tube to pilot burner. 

 Refit main burner and sole plate(s). 

 Refit lower lintel. 

3. 

To replace the low fire screw in the static oven gas valve:- 

 Remove the oven control panel. 

 Remove low fire screw from gas valve and replace with  

correct size low fire screw as shown in ‘Gas Specifications 

Tables’ at end of this section. 

NOTE: The 'Low Fire Screw' should be sealed with coloured 

paint on completion of low fire adjustment. 

 Refit the oven control panel. 

Gas Regulator 

NAT Gas / LPG / Butane Only. 

NOTE:  The gas regulator supplied is convertible between Natural Gas and LP Gas, but it’s outlet  

pressure is fixed ex-factory and is NOT to be adjusted. 

- Town Gas Only. 

1. 

Remove slotted cap from regulator. 

2. 

Turn ‘On’ gas supply and appliance. 

3. 

Adjust pressure adjusting screw to achieve correct burner 

operating pressure. 

NOTE:  Operating pressure to be measured at manifold test 

point with two burners operating at 'High Flame' setting. 

4. 

Verify operating pressure remains correct (Re-adjust regulator if required). 

5. 

Screw cap nut back onto regulator. 

Low Fire Adjustment Screw 

Pressure Adjusting 

Screw 

Cap Nut