Waldorf RN8410G Installation And Operation Manual - page 18
16
Cleaning and Maintenance
Open Burner Cleaning
1. Remove pot stands, burner caps, burner bowls
and pot stand supports from top of cooktop.
Wash with hot soapy water, using a soft
bristled brush. Dry thoroughly with a dry cloth.
Any baked-on deposits can be scraped off
using a scraper tool.
NOTE: Pot stands, burner bowls and pot stand
supports can be washed in a dish
washer. Do Not wash burner caps in
dishwasher.
2. Burner mounting rails should not be removed.
Clean in situ with hot soapy water.
3. Clean burner venturi with a bottle brush and
hot soapy water, as required.
4. Empty spill tray and wash with warm soapy
water.
5. Dry all components thoroughly and
re-assemble.
Griddle Plate Cleaning
It is recommended that a flat blade scraper is used
to clean the griddle surface, these are not supplied
with griddle but may be purchased separately.
Refer to 'Replacement Parts List' at rear of this
manual.
1. Clean griddle plate surface thoroughly with a
scraper tool and brush off any deposits with a
soft bristled brush.
2. Stubborn or accumulated carbon deposits can
be removed with a griddle stone or a scotch
bright pad.
3. Wipe down griddle surface with a cloth and
then clean with hot soapy water and a soft
bristled brush. Dry thoroughly with a dry cloth.
4. Occasionally bleach griddle plate with vinegar
when plate is cold.
5. Empty grease tray and wash with warm soapy
water. Dry thoroughly with a dry cloth. Refit
grease tray.
6. Briefly turn ‘On’ griddle until griddle plate is
dry.
7. Spread a thin smear of cooking oil over griddle
plate to form a protective film.
Always ensure that even pressure is
applied over whole surface of scraper tool
when using on flat surface of griddle, to
prevent scoring of griddle surface.
NEVER bang sharp edge of scraper tool on
flat surface of griddle as this will damage
the griddle and invalidate the warranty.
Caution
T
HE
BLADES
FITTED
TO
THE
SCRAPER
TOOL
ARE
EXTREMELY
SHARP
AND
ARE
TO
BE
USED
WITH
CARE
.
Warning
Burner Cap
Burner Body
Burner Mounting
Rail
Pot Stand
Support
Burner Venturi
Bottle Brush