Waldorf RN8410G Installation And Operation Manual - page 16

14 

Operation

Oven 

Oven Pilot Ignition 

1. 

Open oven door.  Depress thermostat control knob and 

rotate anti-clockwise to ‘PILOT’ position. 

2. 

With gas control knob depressed, press piezo ignition 

button to ignite pilot burner.  Repeat Items 1 to 2 until 

pilot is lit. 

3. 

Release gas control knob approximately 10-20 seconds 

after lighting pilot, until pilot thermocouple is heated up 

by pilot flame. 

4. 

Pilot should now remain alight.  If pilot does not light, 

repeat Items 1 to 3 above. 

5. 

View pilot burner through holes in front of burner box 

with oven door open.  See Fig 4. 

Oven - Main Burner / Thermostat 

1. 

With pilot burner alight, rotate thermostat control knob anti-clockwise to desired oven temperature 

setting required, this will regulate gas supply to burner. 

2. 

To turn main burner ‘OFF’, simply turn thermostat control knob clockwise to ‘OFF’ position. 

Turning the Oven to ‘Standby’ (Pilot ‘ON’ Only) 

1. 

To turn off oven burner / heating, set oven thermostat to ‘PILOT’ position, this will turn oven ‘OFF’, 

but leave oven pilot burner ‘ON’. 

2. 

In this position pilot burner will remain alight, but main burner will not operate until thermostat 

control knob is set to a temperature. 

3. 

If pre-heating of oven is required, set thermostat control knob to temperature 190°C and allow 20 

minutes before cooking in oven to allow oven to warm up. 

Oven ‘Shut-Down’ 

1. 

To turn oven to ‘PILOT’ position only, rotate thermostat control knob clockwise until pilot position is 

reached.  In this position only pilot burner will remain on. 

2. 

To ‘Shut Down’ oven, depress and turn thermostat control knob to ‘OFF’ position.  This will turn 

‘OFF’ oven and extinguish pilot burner.  To re-light pilot burner, refer to ‘Oven Pilot Ignition’ in this 

section. 

Pilot Burner 

viewing holes 

Fig 4 

! IMPORTANT 

DO NOT USE aluminium foil or trays directly on cast iron sole plate(s). NEVER 

block or cover openings on each side of sole plate(s). 

IMPORTANT: 

Should any abnormal operation like; 

- ignition problems, 

- abnormal burner flame, 

- burner control problems, 

- partial or full loss of burner flame in normal operation, appliance requires IMMEDIATE 

service by a qualified service person and should not be used until a service is carried out. 

Be aware that when opening the oven door, hot air and cooking vapours will 

be released from the hot oven. 

Caution